PEAKDIP is designed for use in the foundry or steelworks, to give the furnace operator, a Metal Temperature, displayed immediately after he has made a dip.
It is available, as standard, for use with type 'B', 'K68', 'K48', 'R68', 'R48', 'S68' or 'S48', thermocouple, degrees Celsius or Fahrenheit. SPECIFY!
ITS 90 calibration is supplied as standard, alternatively IPTS 68 or IPTS 48 calibration may be specified.
MELTING TEMP. CONTROL
PEAKDIP may be used as the melt temperature input transmitter to the melting furnace temperature controller or computer: The peak held temperature acts as "measured value", until updated by a further temperature measurement.

'PEAKDIP' SPECIFICATION THERMOCOUPLE RANGES:

1. 1. PD'B' 90 300 to 1820 deg. Celsius for Pt30%Rh/Pt6%Rh (570 to 3310 deg. F)
   2. PD 'K68' or 'K48' -270 to 1372 deg. C NiCr/NiAl (-450 to 2500 deg. F)
   3. PD 'R68' or 'R48' 0 to 1768 deg. C Pt13%Rh/Pt (0 to 3214 deg. F)
   4. PD 'S68' or 'S48' 0 to 1768 deg. C Pt10%Rh/Pt (0 to 3214 deg. F)

• AUTOMATIC Cold Junction Compensation
• CALIBRATION: IPTS-68 (BS4937: DIN 43 710) - STANDARD Other calibrations on request; e.g. IPTS'48 or ITS'90.
• ACCURACY: +/- 0.1% of reading + 1 DEGREE C or F
• RESOLUTION: 0.1 DEG. UP TO 200 then 1 DEGREE C or F
• AMBIENT TEMPERATURE RANGE: 0 to 45 DEG.C (32 to 113 DEG.F)
• POWER SUPPLY: 110/220 or 240V, 50/60Hz. Specify!
• DISPLAY: 25 mm Bright Red
• LED BROKEN THERMOCOUPLE .... DISPLAY shows '--' (FLASHING)
  BROKEN THERMOCOUPLE, during a measurement... Latest 'MEASURED VALUE' displayed + Display "FLASHES'
  REVERSED INPUT... changes to '--' (FLASHING)
  AUTOMATIC PEAK HOLD OF READING....Indicator only DOWNLOAD/ PRINT-OUT of result.... Automatic at end of measurement.